AnOut#

(analog out #) = X

Not supported in 32-bit boards, e.g. EC1, HMI430, DT16 (anything that reports dialect 100 or greater)

Analog output (8-bit mode). The # must be replaced by a letter designating the required analog channel, e.g. AnOutA

The 8-bit integer number in X is converted to an analog quantity (voltage or current, depending on the model of SPLat board) on the designated output channel. For the bidirectional channels on the OEM36 this becomes the voltage against which the corresponding input is compared.

Note: This instruction is not recommended for new designs in controllers that can support dialect 18 or later. Use fAnOut instead. It will not be supported in 32-bit controllers.

See also AnIn fAnOut fAnIn

If you are using the MMi200 please click here for information on a restriction on using this instruction.